IRS Triple Shock Mount Kit. There should be another ring shaped. About 1/8-inch toe in for the front). That has been converted into a sandrail. You load this with good quality wheel bearing grease.
Vw Super Beetle Rear Suspension Diagram
The other half of the proceedure may just put it where it should. Loose and allowing the two wheel bearings in the brake hub assembly. This involves welding the diagonal strut supports. Rear Shock Absorber, IRS Type 1 and 3, 113-513-031NBR fits IRS Type 1 and 3 rear ends. End which connects between the stub axle and the gearbox. After 1969 both have independent rear.
Vw Beetle Front Suspension Types
Wheel off the ground. This "Quick Adjuster" is designed to be welded into the Fabbricated Rear Torsion Bar Securing Section. Question continued -- Slowly and carefully, we pulled the spring. An arc as per the original VW design. You have to put a spirit level on the axle itself. Be, also bringing out the bottom of the tires a bit. The car), and the spring plate can't move much more than this --. Vw beetle front suspension types. Rear tyres are out at the bottom and in at the top, it's sagging.
Vw Beetle Front Suspension
Super-Tight bolts can be aided by grabbing the OD of the bolt with 10" Vice-Grips, and turn the Vice-Grips AND ratchet AT THE SAME TIME to crack it loose. The spring plate should really only ever contact the. The cover over the torsion bar tubes near the front of the fender, but the job doesn't change there at all (it does if you have to. Super Beetle with Automatic Stick Shift and all 1969 and later. Volkswagen beetle front suspension. Pehaps you can sit the car on axle stands. VW Service and Parts. With a normal Beetle, the weight of the car as you jack up under. Where the line of body attachement bolts are fixed (the ride height.
1968 Vw Beetle Rear Suspension Diagram
Of the rear of the spring plate for each movement helps too. That's how they are lubricated. And '70 swing axles in Europe and Australia -- USA had IRS then). Wheel Bearing (Axle Bearing), Rear Outer, 1964-70 Type 2, 211-501-283 is a single bearing nearest the wheel (outside).
Vw Beetle Rear Suspension Diagram
Kit includes 10 pieces. Rear Axle Nut, 36mm, 1967+ Type 1 & 3, 311-501-221HD. If you can lift the side of the car high enough so the oil flows. Mid Travel End Plate Kit, PAIR. If you do, find a couple of longer bolts to get the plate started, them replace. I guess it's also worth checking type pressures and tyre type. Vw super beetle rear suspension diagram. Once completely packed with grease, place the cage over. The spring plate should then rest at about a 20. degree down angle (assuming the floor of the car is level). And, many European and Mexican Beetles had Swing Axles well after 1969, so it's best to verify you have IRS rather than buying these based on the year of your car. IRS Axle Assembly, 1969+ Beetle, Super Beetle, and Ghia, One Side, 113-598-331EC is a brand new Hardened Steel Axle, 2 CV Joints, and 2 CV Boots ready to install! Absorber lower mounting horn on the axle tube as a handle to hold.
The drift and working your way around the bearing to work it out. Assembly on the IRS models, since the axle does not have to be pulled. It's all available here in the VW Online Store. Suspension, and wear in any one of them might result in the symptoms. Urethane IRS Axle Cover Set, Red. Plate off the end of the torsion bar and rotated it counterclockwise.