Some used Hiace vans for sale can have sliding doors that are stuck. The automaker won't comment on whether it is aware of any deaths or injuries that have occurred as a result of the defect. Toyota is still working on a fix and anticipates notifying owners of the problem in mid-January. The Basics: Toyota is recalling 744, 437 Sienna minivans from models years 2011 through 2016 in the United States because their sliding doors may not close properly. If you hear the motor working and hear a metal to metal sound then the cable in the latch assembly has broken apart. You can use the PEX tubing to create your own bushings. Make sure you do not damage the paint and the pin. It is held on by 3 bolts on the back of the door and 3 bolts inside the door. I just came back from Dealer, They tell me it's a motor. Other suggestions: 2012 Toyota Sienna Sliding Door Cable Replacement LH. Toyota sienna sliding door won'to open in a new. 2nd Step: Access the Track. Once you've done that, you can now put the assembly back together. Owners may contact Toyota customer service at 1-800-331-4331.
If it only makes some sound without opening the door, then there must be something wrong with the latch. In the rear of the Hiace van, you will find the tailgate. What other people do is removing the cover panel then remove the inside metal panel to gain access to the latch unit. HOW TO REPLACE/REPAIR SLIDING DOOR CABLE ON A TOYOTA SIENNA 04 05 06 07 08 09 10. Thankfully, in some cases, lubricating the parts does the trick. But if you pull the handle and hold it for a few seconds the door opens. The bad news is you can't just get this part, you need the whole latch assembly which you can get for about $130ish on ebay. Toyota sienna sliding door won't open in a new. Symptom: When you press a button to automatically open the sliding door it makes noise attempting to open the door but fails. NEW YORK — Toyota is recalling more than 700, 000 Sienna minivans in the U. S. because of problems with the latch that can cause the sliding doors to open while the car is in motion. The label on the motor shows the part number (6th picture).
My method: Only partially open the cover panel, lift its bottom up and use a box (or anything) to hold it up. Went to other side, it doesn't do it. 2007 Toyota Sienna Sliding Door Repair. My method is cheap, about $4 ($6. Sienna sliding doors freezing shut- HELP PLEASE. Showed it to mechanic, he said all do it. You can hear the motor but it does not pull the door in to latch. After a couple of months of putting off the repair, the battery, which was over three years old, went totally dead. Need up to 30 seconds to load. Close the sliding doors, then move the track cover about an inch toward the rear. Fixed Toyota Sienna power sliding door problem. The fix: So far unknown. Step 2: Open the Inside Door Panel.
3rd Step: Clean the Assembly. How To Fix A Power Slide Door That Won't Open Properly On A 2004 - 2010 Toyota Sienna The Cheap Way. 2001 Sienna rear sliding door problems. You may need a magnifying glass to view the flat side of the motor shaft. Take out the screws for the taillight, then disconnect the pin in front of the exposed assembly. Sounds like the power slider latch assembly or track have gone bad. The problem, which affects the model year 2011 to 2016 Sienna, occurs when the sliding door is "impeded" while opening automatically. Keep in mind that they won't work the same as the old ones.
Usually you have to disable or unsuccessfully attempt a few times to get the door to close without the motor resistance, but this door will allow me to close without any resistance manually. However, they are the cost-effective and easy fix for faulty rear rollers. Be careful not to drop the bolt, but if you do, you can retrieve it using a magnetic tool.
I know this is old, but I have the answer so figured I would post so others can see. The 4th picture shows a closer look at the motor. If you are not confident that you can do this on your own, you can bring your HiAce van to an expert mechanic. Generate Transcript. My method is pretty generic, it may apply to other car models. After removing the metal panel, it is still not easy to remove the latch because it uses non-standard fasteners. Once you partially open the cover panel you will see the latch (see the picture). Just got this last year, bought it CPO with 28, 000 miles. Close the sliding door of your Hiace van. Align the flat shaft of the motor and insert it. When it gets to the end of the open sequence, it can be closed without any resistance - if that makes sense. The 5th picture shows the cutout piece of the latch. 4th Step: Lubricate. Step 1: Symptom of Sliding Door Latch Problem.
The 3rd picture shows what you see after you cut it open, the motor of the latch. Gently slide a soft cloth over the cable and track. Details: Driver's side door opens automatically from any button, appropriately. They were time consuming, high risk, and more expensive. Wonder if anyone else has had this issue... In this case, it is best that you replace the latch unit. Quick Fix for the Rollers.
Injuries/Deaths: In an emailed statement, a spokesperson for Toyota said, "We would like to refrain from commenting on this matter. Pulling and holding the handle for a few seconds might open the door, but this is only a temporary workaround. Throughout the day, several people slide the door open and close, handling it differently. Almost $700 before labor. Drivers side power slide door will close but will not latch. Sharing buttons: Transcript. 70 (after tax and shipping) for each door. No need to remove the inside metal panel. Once you've cleaned the assembly, you can now lubricate it. If you're using your Hiace van to transport commuters, it is more likely for the sliding doors to become too stiff or broken. It's time-consuming and many things could go wrong. This sounds like what I'm experiencing.
70 after tax and shipping in Minnesota) each door and it took me less than an hour, seriously!!! Finally they admitted they didn't know what was causing it.