To cycle through these temperature levels simply press the power button once. Handle extra care when handling your bubbler, First clean the carb cap and the glass piece by soaking it onto a solution of 91%isopropyl alcohol. If you encounter a software issue, turn the Puffco Peak off and on. Make sure to be careful looking after the LED lights to tell what's wrong with the Puffco Peak.
- Puffco peak pro flashes white and red laser
- Puffco peak pro flashes white and red led
- Puffco peak flashes all colors
Puffco Peak Pro Flashes White And Red Laser
Edit: I'm so glad this post has helped some people. Make sure that all the components are completely dry before attaching it to the Puffco Peak body. During use, wait for a minute before using again. Apart from what the Puffco Peak tells you with its LED lights, here are some of a few things you should avoid when using the Puffco Peak. Multi-Colored LED Lights.
3 Red Flashing Light – Low Battery Level. Peak Pro flashing white and red after update. The medium heat profile runs at 500 degrees and reaches peak temperature at 20 seconds and works well with medium sized loads of concentrates. Avoid storing the Puffco Peak on a moist and humid area. Never Do The Following: Be mindful of the water level of the glass bubbler.
Puffco Peak Pro Flashes White And Red Led
Puffco Peak is equipped with an LED light system that tells you the actual status of the Puffco Peak. The Puffco Peak lets you check the battery level so you'd know when it's time to charge your device. When in use and you want large cloud production, take several short draws instead of long drags. Do not overfill the glass bubbler. Fill it with water just above the air holes. Never store the Puffco Peak with water on the bubbler.
Puffco Peak 4 unique temperature profiles. Can't find anything about this. Temperature Settings. Here's what you should look out for. Finally, the aptly named peak temperature setting heats up your concentrates at 600 degrees and has a 25 second heat up time and can vaporize XL loads of concentrates. The high temperature level is at 550 degrees and reaches vaping temperature at 25 seconds and works best with large loads of wax concentrates. Lower temperature level is at 450 degrees heating up at 20 seconds and works well with small loads of concentrates. Do not overfill the bowl. This can cause liquid to trickle down to the battery and make its way to some of the sensitive internal circuitry which can cause permanent damage. I am in contact with support still. Avoid heating the atomizer 4 times in a row. Leave it in the solution for 30 min to an hour and rinse it with warm water and soap, Dry with a paper towel and set aside. 5 Flashing Light – Short Circuit.
Puffco Peak Flashes All Colors
Unfortunately for me I have purchased a new chamber(tested on friends Pro, it works) and used another one, so a total of 3, but unfortunately my Peak is still giving me the same error light. Do NOT attempt to disassemble the atomizer before submerging fully assembled into ISO. Remove and replace the glass bubbler carefully and do not apply too much force. High, mostly colored in green means that your battery is around 100 – 60 percent while medium or yellow means that you're running at 60 – 30 percent of battery while low or red means you're at 15 – 0 percent of battery power. WARNING: *After cleaning, allow all parts to thoroughly dry before use. When loading avoid wiping off the concentrates on the side of the bowl. Solid Red Light – Overheating.
Drop the fully assembled atomizer into ISO for with a paper towel and set aside. Take the atomizer and soak onto the same solution you used when cleaning the glass bubbler. The battery is represented in three levels. Do not get the base wet – it's electric – it will break.